T Press Resistance to Galling Heavy Duty Engineered Brass alloy cylinder.
Tip: to run it smoothly loosen the screw on shaft slightly till when the dowel on shaft can move but not fall, it makes it easy to move through cylinder.
5" fully released
3.5" fully pressed
Outer cylinder diameter is 25.4mm ( one inch) and inner diameter is 19.5mm ( 0.77 inch) , Cylinder height is 2 1/2"
Handle length 2 1/4",
Weight 7oz/180g,
It can be heated
Another tip: use a thin coat of Olive oil before each use to get the finest result.
Caring:
Clean the item thoroughly with warm water and dishwashing soap for the first time use.
Run it empty for few times and clean it again to make sure oil residue from manufacturing gets washed off.
Before using it, each time please use parchment paper, otherwise your pollen may stick to cylinder.
If the cylinder gets sticky due to pollen residue, please use Alcohol or oil based cleaners to remove the residue
Why Brass Cylinder?! Because Brass is good when it comes to bearings, Valves and whatever goes under high pressure. It is so durable under pressure. Also, Brass is stiffer than Aluminum. Metals such as brass are often chosen for bearings, bushings, and other sliding applications because of their resistance to galling. Maybe Aluminum is good to make Grinder but not for press. This Press is designed by Engineers to handle very high pressure . It has two Dowels to distribute even pressure. You must try it to see the difference.
.jpg "TitanOwl")
